Login | Register

Application of PCM to shift and shave peak demand: Parametric studies

Title:

Application of PCM to shift and shave peak demand: Parametric studies

Karim Lee, Ali (2014) Application of PCM to shift and shave peak demand: Parametric studies. Masters thesis, Concordia University.

[img]
Preview
Text (application/pdf)
Karim_Lee_MSc_F2014.pdf - Accepted Version
4MB

Abstract

Space conditioning is a main contributor to energy usage in buildings. In Quebec, electric baseboard heaters are the predominant household space-heating systems, in the other words, electrical energy is the main source of energy used for space heating. Thus in such a cold climate like Quebec, residential peak heating demand is a significant contributor to high and critical electricity grid peak periods. Reducing peak heating demand by shifting a portion of peak heating demand to off-peak period is thus of high interest. On the supply side, this strategy requires less generated power, and on the demand side it helps downsize heating systems. One possible approach to shifting peak heating demand to off-peak time is to store thermal energy during off-peak periods and release the stored energy during peak periods. To adopt this approach, set-point temperature of heating systems can be lowered during the peak period, while a release of stored energy maintains the indoor temperature within the desired comfort zone. This capability could be implemented using the concept of latent heat, offered by phase-change-material (PCM)–impregnated building wallboard, such as PCM-gypsum wallboard. In this thesis, a PCM module within TRNSYS software is first validated with experimental data, available in literature, for a simple case of one cubicle. The code is then applied to a typical one-story residential building, also modeled in TRNSYS. Later, several parametric studies are carried out to investigate the influence of PCM’s thermal properties and convective heat transfer coefficient on the rate of PCM’s thermal discharge and its resulting improvement in indoor air condition. The simulation results reveal that it is possible to maintain a trade-off between shifting the peak heating demand and preserving thermal comfort by applying PCMs with proper characteristics. It was observed that improving thermal conductivity of PCM has a negligible impact on heat discharge during peak time. Simulations also show that the PCM melting temperature range should be chosen closest to the assigned set-point temperature. It has been shown that increasing the thickness of the PCM layer more than a certain value, 0.013 m, has no effect on thermal storage or, therefore, on PCM thermal discharge. Investigation of interior convective heat transfer on PCM discharge reveals that for a specific climate and PCM wallboard, there is a threshold for effective performance of PCM. For a building located in Montreal, it was shown that with a typical PCM-gypsum wallboard, the interior heat transfer coefficient has to be at least 6.6 W/m2K to sustain the desired thermal comfort. Finally, thermal behavior of the building integrated with PCM wallboards was assessed in three different climates and by applying two different PCM-gypsum wallboards. It was found that PCM wallboard selection and set-point temperature control strategy must be considered according to the outdoor weather conditions.

Divisions:Concordia University > Gina Cody School of Engineering and Computer Science > Building, Civil and Environmental Engineering
Item Type:Thesis (Masters)
Authors:Karim Lee, Ali
Institution:Concordia University
Degree Name:M.A. Sc.
Program:Building Engineering
Date:18 August 2014
Thesis Supervisor(s):Haghighat, Fariborz
ID Code:979032
Deposited By: ALI KARIMLEE
Deposited On:03 Nov 2014 14:05
Last Modified:18 Jan 2018 17:48
All items in Spectrum are protected by copyright, with all rights reserved. The use of items is governed by Spectrum's terms of access.

Repository Staff Only: item control page

Downloads per month over past year

Back to top Back to top