Login | Register

Simulation and performance analysis of an active PCM-heat exchanger intended for building operation optimization


Simulation and performance analysis of an active PCM-heat exchanger intended for building operation optimization

Morovat, Navid, Athienitis, Andreas K., Candanedo, José A. and Dermardiros, Vasken (2019) Simulation and performance analysis of an active PCM-heat exchanger intended for building operation optimization. Energy and Buildings, 199 . pp. 47-61. ISSN 03787788 (In Press)

[thumbnail of Candanedo-2019.pdf]
Text (application/pdf)
Candanedo-2019.pdf - Accepted Version
Available under License Creative Commons Attribution Non-commercial No Derivatives.

Official URL: http://dx.doi.org/10.1016/j.enbuild.2019.06.022


This paper presents a simulation study of an active energy storage device intended to enhance building operation. This device –which is designed for installation in the ceiling plenum of an office, a mechanical room or in other convenient locations– consists of an arrangement of several panels of a phase-change material. It may be charged or discharged as required with an air stream passing between the panels, thus operating as a PCM-air heat exchanger (PCM-HX).

The first part of the paper focuses on the design of the PCM-HX. Several design configurations are evaluated; investigated parameters include the PCM-HX dimensions, the number of air channels and airflow rates. The paper also includes an experimental validation of the PCM model. Performance criteria that were considered in the parametric study include the amount of stored heat, the time needed to charge/discharge the PCM storage and the overall energy density of the device.

The second part of the paper evaluates different control strategies aimed at reducing peak demand and the size of HVAC system. The impact on peak load of a linear ramp for the temperature setpoint is investigated: it was found that a two hour linear ramp in temperature setpoint –together with a PCM-HX configuration with six air channels– can reduce the peak heating load by 41% as compared to a benchmark case without the PCM-HX.

Divisions:Concordia University > Gina Cody School of Engineering and Computer Science > Building, Civil and Environmental Engineering
Item Type:Article
Authors:Morovat, Navid and Athienitis, Andreas K. and Candanedo, José A. and Dermardiros, Vasken
Journal or Publication:Energy and Buildings
Date:15 September 2019
  • The Natural Sciences and Engineering Research Council
Digital Object Identifier (DOI):10.1016/j.enbuild.2019.06.022
Keywords:Active PCM heat exchanger; Energy storage; Performance optimization; Peak load reduction
ID Code:985564
Deposited By: Michael Biron
Deposited On:11 Jul 2019 12:54
Last Modified:08 Jun 2021 01:00


S.Ø. Jensen, et al. IEA EBC annex 67 energy flexible buildings
Energy Build., 155 (2017), pp. 25-34

N. Mao, et al. Numerical investigations on the effects of envelope thermal loads on energy utilization potential and thermal non-uniformity in sleeping environments Build. Environ., 124 (2017), pp. 232-244

N. Mao, et al. A numerical study on influences of building envelope heat gain on operating performances of a bed-based task/ambient air conditioning (TAC) system in energy saving and thermal comfort
Appl. Energy, 192 (2017), pp. 213-221

K. Du, et al. A review of the applications of phase change materials in cooling, heating and power generation in different temperature ranges Appl. Energy, 220 (2018), pp. 242-273

Z. Zhou, et al. Phase change materials for solar thermal energy storage in residential buildings in cold climate Renew. Sustain. Energy Rev., 48 (2015), pp. 692-703

J. Paris, M. Falardeau, C. Villeneuve Thermal storage by latent heat: a viable option for energy conservation in buildings Energy Sources, 15 (1) (1993), pp. 85-93

N. Soares, et al. Review of passive PCM latent heat thermal energy storage systems towards buildings’ energy efficiency Energy Build., 59 (2013), pp. 82-103

S. Bourne, A. Novoselac Compact PCM-based thermal stores for shifting peak cooling loads Building Simulation, Springer (2015)

Z.J. Yu, et al. Control strategies for integration of thermal energy storage into buildings: state-of-the-art review Energy Build., 106 (2015), pp. 203-215

U. Berardi, S. Soudian Benefits of latent thermal energy storage in the retrofit of Canadian high-rise residential buildings Building Simulation, Springer (2018)

A. Pasupathy, R. Velraj Effect of double layer phase change material in building roof for year round thermal management Energy Build., 40 (3) (2008), pp. 193-203

F. Kuznik, J. Virgone Experimental investigation of wallboard containing phase change material: data for validation of numerical modeling Energy Build., 41 (5) (2009), pp. 561-570

V. Dermardiros Modelling and Experimental Evaluation of an Active Thermal Energy Storage System with Phase-Change Materials for Model-Based Control Concordia University (2015)

A.C. Papachristou, et al. A numerical and experimental study of a simple model-based predictive control strategy in a perimeter zone with phase change material Sci. Technol. Built Environ., 24 (9) (2018), pp. 1-12

A. Bastani, F. Haghighat, C.J. Manzano Investigating the effect of control strategy on the shift of energy consumption in a building integrated with PCM wallboard Energy Procedia, 78 (2015), pp. 2280-2285

N. Zhu, Z. Ma, S. Wang Dynamic characteristics and energy performance of buildings using phase change materials: a review Energy Convers. Manag., 50 (12) (2009), pp. 3169-3181

K. Childs, T. Stovall Potential Energy Savings Due to Phase Change Material in a Building Wall Assembly: An Examination of Two Climates Oak Ridge National Laboratory, Oak Ridge, TN (2012) Technical Report No. ORNL/TM-2012/6

E. Bigaila, A. Athienitis Modeling and simulation of photovoltaic /thermal air collector assisting a façade integrated small scale heat pump with radiant PCM panel Energy Build., 149 (2017), pp. 298-309

A. Athienitis, et al. Investigation of the thermal performance of a passive solar test-room with wall latent heat storage Build. Environ., 32 (5) (1997), pp. 405-410

M.M. Farid, et al. A review on phase change energy storage: materials and applications Energy Convers. Manag., 45 (9–10) (2004), pp. 1597-1615

N. Soares, C.F. Reinhart, A. Hajiah Simulation-based analysis of the use of PCM-wallboards to reduce cooling energy demand and peak-loads in low-rise residential heavyweight buildings in Kuwait Building Simulation, Springer (2017)

S. Nikoofard, V.I. Ugursal, I. Beausoleil-Morrison Techno-economic assessment of the impact of phase change material thermal storage on the energy consumption and GHG emissions of the Canadian Housing Stock Building Simulation, Springer (2015)

F. Guarino, et al. PCM thermal storage design in buildings: experimental studies and applications to solaria in cold climates
Appl. Energy, 185 (2017), pp. 95-106

A. Mosaffa, et al. Thermal performance of a multiple PCM thermal storage unit for free cooling Energy Convers. Manag., 67 (2013), pp. 1-7

Morovat, N. and A.K. Athienitis, Impact of building-integrated PCM on the indoor thermal environment and energy performance of an office zone, in 12th IIR Conference on Phase-Change Materials and Slurries for Refrigeration and Air Conditioning (PCM 2018). 2018: Orford(Québec), Canada. p. 8.

A.S. Fleischer Fundamental thermal analysis Thermal Energy Storage Using Phase Change Materials, Springer (2015), pp. 75-85

J. Heier, C. Bales, V. Martin Combining thermal energy storage with buildings–a review Renew. Sustain. Energy Rev., 42 (2015), pp. 1305-1325

G. Hed, R. Bellander Mathematical modelling of PCM air heat exchanger Energy Build., 38 (2) (2006), pp. 82-89

B. Zalba, et al. Review on thermal energy storage with phase change: materials, heat transfer analysis and applications Appl. Therm. Eng., 23 (3) (2003), pp. 251-283

DuPont, DuPont Energain - Energy-saving thermal mass systems. Availabe at: 2/15/2019 http://www.cse.fraunhofer.org/hs-fs/hub/55819/file-14736951-pdf/docs/energain_flyer.pdf.

V. Dermardiros, A. Athienitis Comparison of PCM-active thermal storage systems integrated in building enclosures 10th Conference on Advanced Building Skins (2015)

Z. Afroz, et al. Modeling techniques used in building HVAC control systems: a review Renew. Sustain. Energy Rev., 83 (2017), pp. 64-84

P. Tabares-Velasco, C. Christensen, M. Bianchi Simulated peak reduction and energy savings of residential building envelope with phase change materials ASHRAE Trans., 118 (2) (2012), pp. 90-97

J. Le Dréau, P. Heiselberg Energy flexibility of residential buildings using short term heat storage in the thermal mass Energy, 111 (2016), pp. 991-1002

G. Reynders, et al. Energy flexible buildings: an evaluation of definitions and quantification methodologies applied to thermal storage Energy Build., 166 (2018), pp. 372-390

R. Barzin, et al. Application of weather forecast in conjunction with price-based method for PCM solar passive buildings–an experimental study Appl. Energy, 163 (2016), pp. 9-18

D.B. Crawley, et al. Energy plus: energy simulation program ASHRAE J., 42 (4) (2000), pp. 49-56

M. Manning, et al. The effects of thermostat setting on seasonal energy consumption at the CCHT research facility CCHT Rep. (2005)

J.W. Moon, S.-H. Han Thermostat strategies impact on energy consumption in residential buildings Energy Build., 43 (2–3) (2011), pp. 338-346

J.A. Candanedo, et al. Near-optimal transition between temperature setpoints for peak load reduction in small buildings Energy Build., 87 (2015), pp. 123-133

J.E. Braun, K.-H. Lee An experimental evaluation of demand limiting using building thermal mass in a small commercial building ASHRAE Trans., 112 (1) (2006)

K.-h Lee, J.E. Braun Model-based demand-limiting control of building thermal mass Build. Environ., 43 (10) (2008), pp. 1633-1646

R. D'Angiolella, M. de Groote, M. Fabbri, NZEB 2 Interactive players in an evolving energy system REHVA J, 53 (2016), pp. 52-55

R. De Coninck, L. Helsen Bottom-up quantification of the flexibility potential of buildings, in: building Simulation 13th International Conference of the International Building Performance Simulation Association, Aix-les-Bains, France, IBPSA (2013)
All items in Spectrum are protected by copyright, with all rights reserved. The use of items is governed by Spectrum's terms of access.

Repository Staff Only: item control page

Downloads per month over past year

Research related to the current document (at the CORE website)
- Research related to the current document (at the CORE website)
Back to top Back to top